Ptac Wall Sleeve Installation Instructions

Page 3 pre installation considerations before proceeding with the sleeve installation ensure the following guidelines for locating the wall opening and sleeve are met.

Ptac wall sleeve installation instructions.

Wall sleeve installation 920 087 04 8 05 wall sleeve installation instructions pdxws note. The air conditioner will slide into the sleeve but is not flush with the wall. This information might be about you your preferences or your device and is mostly used to make the site work as you expect it to. When a drain kit is to be installed do so before top of wall sleeve installing the wall sleeve in the wall.

There is a portion of the air conditioner which extends a few inches back into the room. All wall and window wall installations must provide for proper drainage. If the sleeve projects more than 8 into the room a sub base or other means of support must be used. See the drain kit for internal actual installation instructions.

For sunrooms and modular buildings adhere to their installation instructions for supporting and sealing sleeve to their frames. Consult a licensed contractor as needed. Standard steel wall cases are 42 w 16 h 13 3 4 d. In applications where the drain holes on the ptac wall sleeve are not exposed beyond the wall an internal drain system is recommended.

To ensure proper airflow and filter removal it is recom mended installation of the wall sleeve be a minimum of 36 from the ceiling. Inches mm inches mm inches mm wall sleeve only 3 75 0 0 0 0 subbase kit 3 75 3 1 4 85 2 3 4 70. Insure that the unit is only installed in a wall structurally adequate to support the unit including the sleeve chassis and accessories. The wall sleeve must be fastened securely before installing the air conditioner unit.

Wall case must be sealed caulked to outside wall on all four 4 sides. Figure 4 minimum interior and exterior note. 16 24 28 and 31 deep cases are available for thicker walls. In applications where the drain holes on the ptac wall sleeve are not exposed beyond the wall an internal drain system is recommended.

The wall sleeve be installed a minimum of 36 from the ceiling. All wall and window wall installations must provide for proper drainage. Wall case should be sealed caulked to the inside wall on all four 4 sides. Installation guidelines for sealing ptac sleeves read these instructions completely before starting any installation.

Prepare and install the new wall sleeve according to the instructions below. Tools required by. While the dimensions may appear to be incompatible the 2 devices should fit properly. When you visit any website it may store or retrieve information on your browser mostly in the form of cookies.

The sleeve will fit flush in the wall extending outside the structure.