Fit the straight outer leg into the mounting rail first and then snap in the inner leg which may have a hook.
Pella how to remove storm door lock.
Pretty scary thinking that storm door wouldn t open properly in case of emergency.
Start at the top end and slide your finger down the strip while pressing firmly.
Using a rasp or file carefully remove excess material from bottom of each hole in strike plate about 1 8.
This loosens the tension in the hinges to make the door easier to open.
Use pencil to mark on strike plate location of deadbolt and spring latch.
The pella contact suggested removing the screw cover strip on the latch side and removing the 5 screws holding the latch side trim.
Remove the lock body.
Use the screwdriver to chisel out any wood in the frame that may prevent the door from latching.
Contacted pella storm door service at 866 809 9460.
This will loosen the tension on the deadbolt allowing it to retract and the door to open.
If either does not operate when the door is open the hardware needs to be replaced.
Open door and remove strike plate.
If one or both legs are damaged or bent the screw cover strips need to be replaced.
Had to replace this hardware.
Reinstall strike plate and test operation.
Remove the screws from the latch.
This is a waste of time because the striker plate is still held firmly by 3 screws you can t get to.
Move the latch to the left or right as needed.
The storm door guy does a step by step walk through on how to disassemble a storm door handle in this case specifically a pella select or ashford model.
Place the new mortise lock.
Loosen the set screw.
Replace the screws and tighten.
The hinge rail runs vertically along the hinge side of the door.
Remove the screws and cover plates.
Using an allen key loosen the set screw and remove the interior door handle.
Steps for replacing the lock and hardware on a storm door.